Jump to content

Variation & Optimization

Anything related to manual/automated design creation and variant management.

109 topics in this forum

  1. Batch Mode

    By Jörg,   
    • 11 replies
    • 17455 views

  2. CAESES and workbench use Fluent to optimize the design and cause failure

    By sisi,   
    • 6 replies
    • 243 views

  3. Dakota Local Optimization question

    By Yukai,
    • 1 reply
    • 88 views

  4. Toggle All for script

    By yuvraj,
    • 1 reply
    • 87 views

  5. Chart Colouring

    By CJ Coll,
    • 2 replies
    • 163 views

  6. How to set constraints so that CFD can only run the desired results

    By Yukai,
    • 2 replies
    • 149 views

  7. Batch Mode Runs

    By yuvraj,
    • 2 replies
    • 156 views

  8. Sobol Specific Variants

    By CJ Coll,
    • 3 replies
    • 154 views

  9. Sobol Optimisation Hull Exporting

    By CJ Coll,
    • 3 replies
    • 181 views

  10. Response Surface Optimization without CFD run

    By Furkan Tercanlı,   
    • 4 replies
    • 220 views

  11. How to prevent the voilated design to run

    By Furkan Tercanlı,   
    • 1 reply
    • 217 views

  12. openfoam optimization parameter settings questions

    By Yukai,   
    • 5 replies
    • 402 views

  13. Lackenby Generalized Shifts - Parallel mid body

    By Carlos Almeida,
    • 9 replies
    • 694 views

  14. Evaluations not influenced by design variables

    By Carlos Almeida,
    • 11 replies
    • 574 views

  15. Updating Design Engine after Baseline Design Changes

    By Junwei,
    • 1 reply
    • 259 views

  16. Some questions about CAESES ACT、 workbench and propeller feature

    By Graychen,   
    • 10 replies
    • 995 views

  17. Exporting modified geometry after offline edits to Caeses batch script

    By KNL21,   
    • 5 replies
    • 603 views

  18. Create Geometry in Batch-Mode

    By CHenk,
    • 5 replies
    • 528 views

  19. Free Form Deformation offsetbox failed

    By Junb Liu,
    • 1 reply
    • 422 views

  20. Optimization with Connection to Fine Marine

    By Solehah,   
    • 2 replies
    • 463 views

  21. Free Form Deformation of bulb

    By Rull,
    • 9 replies
    • 2547 views

  22. Desing Viewer Error

    By Osman,
    • 1 reply
    • 643 views

  23. Saving IGES Files from Sobol Sequence

    By Martyn Matiba,
    • 1 reply
    • 566 views

  24. Ship Hull Form Optimization

    By Rizuan Razali,
    • 5 replies
    • 1136 views

  25. CAESES input and response surface visualization

    By MIHCool,
    • 13 replies
    • 1930 views
×
×
  • Create New...