Junb Liu 0 Report post Posted March 9, 2023 Hi I'm trying to set an offset FFD box around a plane. After translating, a disorder plane was got as shown in the figure below. I have got a desired plane if the sweep or rectangular box was employed. Could you please help find out why the offset box does not work? Thanks a lot. Best regards Junb Liu Share this post Link to post Share on other sites
Junb Liu 0 Report post Posted March 12, 2023 Hi The problem is solved because the parameter which controls the distances of box layers from surface was set wrong by myself. 😅 Share this post Link to post Share on other sites