Jump to content

Variation & Optimization

Anything related to manual/automated design creation and variant management.

115 topics in this forum

  1. Batch Mode

    By Jörg,   
    • 11 replies
    • 19067 views

  2. Question about continuity condition in free form deformation

    By Kazem,   
    • 1 reply
    • 38 views

  3. Problems of design variables in the optimization of propeller

    By liuxuyang,   
    • 1 reply
    • 20 views

  4. RSM from CAESES

    By yuvraj,
    • 1 reply
    • 365 views

  5. CAESES Batch Mode: Guidance Needed for DOE and Optimization Setup

    By djusng,   
    • 1 reply
    • 658 views

  6. Modified CSV files cannot be used as result pools

    By Yukai,
    • 1 reply
    • 475 views

  7. SOBOL and NSGA

    By AlexisNav,   
    • 3 replies
    • 449 views

  8. Create Geometry in Batch-Mode

    By CHenk,
    • 6 replies
    • 1495 views

  9. CAESES and workbench use Fluent to optimize the design and cause failure

    By sisi,   
    • 6 replies
    • 1177 views

  10. Dakota Local Optimization question

    By Yukai,
    • 1 reply
    • 561 views

  11. Toggle All for script

    By yuvraj,
    • 1 reply
    • 505 views

  12. Chart Colouring

    By CJ Coll,
    • 2 replies
    • 761 views

  13. How to set constraints so that CFD can only run the desired results

    By Yukai,
    • 2 replies
    • 636 views

  14. Batch Mode Runs

    By yuvraj,
    • 2 replies
    • 842 views

  15. Sobol Specific Variants

    By CJ Coll,
    • 3 replies
    • 740 views

  16. Sobol Optimisation Hull Exporting

    By CJ Coll,
    • 3 replies
    • 747 views

  17. Response Surface Optimization without CFD run

    By Furkan Tercanlı,   
    • 4 replies
    • 1270 views

  18. How to prevent the voilated design to run

    By Furkan Tercanlı,   
    • 1 reply
    • 729 views

  19. openfoam optimization parameter settings questions

    By Yukai,   
    • 5 replies
    • 1042 views

  20. Lackenby Generalized Shifts - Parallel mid body

    By Carlos Almeida,
    • 9 replies
    • 1571 views

  21. Evaluations not influenced by design variables

    By Carlos Almeida,
    • 11 replies
    • 1268 views

  22. Updating Design Engine after Baseline Design Changes

    By Junwei,
    • 1 reply
    • 769 views

  23. Some questions about CAESES ACT、 workbench and propeller feature

    By Graychen,   
    • 10 replies
    • 1946 views

  24. Exporting modified geometry after offline edits to Caeses batch script

    By KNL21,   
    • 5 replies
    • 1285 views

  25. Free Form Deformation offsetbox failed

    By Junb Liu,
    • 1 reply
    • 839 views
×
×
  • Create New...