CJ Coll 0 Report post Posted February 12 I have ran a Sobol Optimisation for a ship hull and want to have a trimesh surface exported for each hull variant. So far I have been saving them all as individual CAESES projects and then exporting the trimesh manually. Is there an easier way to do this? Share this post Link to post Share on other sites
Andreas Arapakopoulos 2 Report post Posted February 13 Hi, Within CAESES, the input and/or output geometry can be automatically exported to the corresponding folder in an optimization setup. You can find a demonstration of the integration of STarccm+ with CAESES in our software by accessing the Help workspace and searching for "star-ccm". Best Regards, Andreas Share this post Link to post Share on other sites
CJ Coll 0 Report post Posted February 13 Thank you, so if I run a basis simulation in the connection part and get my required results, then I go to the optimisation and use Sobol analysis. How do I then run all these hull variants through StarCCM. Or is this done when I run the sobol analysis? Share this post Link to post Share on other sites
CJ Coll 0 Report post Posted February 17 If I have run the initial simulation through CAESES and now I want to run it through the Sobol analysis but I only want to analyse, say, designs 0,8,11,15,19. How can I specify this before CAESES runs all 20 variants through StarCCM, which would take far too long? Share this post Link to post Share on other sites