Jump to content

Variation & Optimization

Anything related to manual/automated design creation and variant management.

116 topics in this forum

  1. Batch Mode

    By Jörg,   
    • 11 replies
    • 19654 views

  2. Exporting IGES Files while running a LHS DoE

    By ahorsky,
    • 1 reply
    • 131 views

  3. Response Surface Optimization without CFD run

    By Furkan Tercanlı,   
    • 5 replies
    • 1672 views

  4. Question about continuity condition in free form deformation

    By Kazem,   
    • 1 reply
    • 428 views

  5. Problems of design variables in the optimization of propeller

    By liuxuyang,   
    • 1 reply
    • 365 views

  6. RSM from CAESES

    By yuvraj,
    • 1 reply
    • 637 views

  7. CAESES Batch Mode: Guidance Needed for DOE and Optimization Setup

    By djusng,   
    • 1 reply
    • 916 views

  8. Modified CSV files cannot be used as result pools

    By Yukai,
    • 1 reply
    • 745 views

  9. SOBOL and NSGA

    By AlexisNav,   
    • 3 replies
    • 783 views

  10. Create Geometry in Batch-Mode

    By CHenk,
    • 6 replies
    • 1822 views

  11. CAESES and workbench use Fluent to optimize the design and cause failure

    By sisi,   
    • 6 replies
    • 1507 views

  12. Dakota Local Optimization question

    By Yukai,
    • 1 reply
    • 840 views

  13. Toggle All for script

    By yuvraj,
    • 1 reply
    • 760 views

  14. Chart Colouring

    By CJ Coll,
    • 2 replies
    • 1230 views

  15. How to set constraints so that CFD can only run the desired results

    By Yukai,
    • 2 replies
    • 1095 views

  16. Batch Mode Runs

    By yuvraj,
    • 2 replies
    • 1140 views

  17. Sobol Specific Variants

    By CJ Coll,
    • 3 replies
    • 1000 views

  18. Sobol Optimisation Hull Exporting

    By CJ Coll,
    • 3 replies
    • 1014 views

  19. How to prevent the voilated design to run

    By Furkan Tercanlı,   
    • 1 reply
    • 1002 views

  20. openfoam optimization parameter settings questions

    By Yukai,   
    • 5 replies
    • 1334 views

  21. Lackenby Generalized Shifts - Parallel mid body

    By Carlos Almeida,
    • 9 replies
    • 1903 views

  22. Evaluations not influenced by design variables

    By Carlos Almeida,
    • 11 replies
    • 1627 views

  23. Updating Design Engine after Baseline Design Changes

    By Junwei,
    • 1 reply
    • 997 views

  24. Some questions about CAESES ACT、 workbench and propeller feature

    By Graychen,   
    • 10 replies
    • 2301 views

  25. Exporting modified geometry after offline edits to Caeses batch script

    By KNL21,   
    • 5 replies
    • 1614 views
×
×
  • Create New...