Search the Community
Showing results for tags 'free form deformation'.
The search index is currently processing. Current results may not be complete.
Found 2 results
-
Hi everybody, I am currently working on a project concerning the optimization of the sonar dome of DTMB (David Taylor Basin Model) 5415. I use free form deformation method to parameterized the geometry of sonar dome. I would like to know how continuity condition for this method in CAESES works (Tangent, Curvature and Position options). Unfortunately no documentation is available on the internet. It is greatly appreciated if anybody could help me understand the effect of the mentioned options. Best Regards, Kazem Reza-Asl -
Hi Everyone, I am working on a nose cone as you can see in the image and I am using the free form deformation method. I control the nose cone with 4 different sections and I have assigned the scale ratio to be used for each section as a different design variable. So there are a total of 4 design variables(r1,r2,r3,r4). Consecutive design variable values should not be less than each other. For example, if r1 is 0.2, the lower bound of r2 should be 0.2. But I can't control it. Any ideas on how to do it? Thank you, Best Regards Osman
