Mr. Suraj Pawar 0 Report post Posted August 22, 2017 I am trying to use the feature "Fit profile data with LE and TE". I have set of points and LE and TE curve in the form of circle. When I try to use this feature it creates NURBS curve and there is an error in creating this NURBS curve. i am not able to figure out what that error is. I have attached the file. Thank you. nacaprofile_trial.fdbc Share this post Link to post Share on other sites
Ceyhan Erdem 14 Report post Posted August 23, 2017 Hi Mr Suraj Pawar, From the picture you have attached I can see that a curve is assigned for point data.Instead of a curve a set of points should have been assigned Please see the attached picture. CheersCeyhan Share this post Link to post Share on other sites
Mr. Suraj Pawar 0 Report post Posted August 23, 2017 Actually in the attached caeses file I have assigned the set of points. Also, curve is assigned for LE and TE. Below is the screenshot attached. Thank You. Share this post Link to post Share on other sites
Jörg 29 Report post Posted September 5, 2017 Hi Suraj, It is a bit difficult without any point data to reproduce your problem. Maybe the point data does not "naturally" fit to the given circles (e.g. too large diameters). Can you try to remove the first and last point of your point data? This could work if I look at your picture. CheersJoerg Share this post Link to post Share on other sites