Ms. liu ellen 0 Report post Posted December 5, 2014 Hello, I want to use Shipflow to predict wave-making of catamaran.But i encounter some problem of mesh below! 1.The taskmonitor indicates that CATA can not be used in XMAUTO mode. But i already change XMMANU(Xflow-hull-meshmod-xmmanu) 2.how to define my cat draft and beam in Xmesh 3.why sometines shipflow says that i have an "error reading array of intergraldata_t" And this is cat main spec.L=97B(one hull)=7draft=3Bcb(the length between two hulls)=18 Hope someone can help me! Thanks a lot! test.fdb Share this post Link to post Share on other sites
Jörg 29 Report post Posted December 12, 2014 Hi Liu Ellen, We recommend you to contact the SHIPFLOW support. I am sure that they can help you very quickly with this SHIPFLOW-related problem. Best regardsJoerg Share this post Link to post Share on other sites