yuvraj 0 Report post Posted March 25 Hello Techie I am running a Dakota RSM based optimization. First I have imported some runs data. Now the problem is, when I am running it in batch mode it is not taking the imported results although in GUI mode, it is able to run the dakota optimization by toggling all. What acommand I should add so that it start taking the imported results while running optimization. // [0.1, 30] |Angle.setValue(20) // [1, 10] |Corner_Fillet.setValue(10) // [11, 16] |cross_Section_radius.setValue(16) // --------------------------------------------------------------- // DESIGN VARIABLES END // --------------------------------------------------------------- // --------------------------------------------------------------- // EXPORTS // --------------------------------------------------------------- // export file name of |Export : hut.stl //|Export.export() // --------------------------------------------------------------- // EXPORTS END // --------------------------------------------------------------- dakota1.run() saveProject() exit(true) Regards Yuvraj Share this post Link to post Share on other sites
Ceyhan Erdem 14 Report post Posted April 2 Hi Yuvraj, Can you please add the following lines; dakota1.setUseResultPool(true) dakota1.run(true) In the Caeses console, using the Ctrl+Space combination provides the available commands that can be used for an entity (dakota1. in this case) Cheers Ceyhan Share this post Link to post Share on other sites