Mr. Li Tongyu 0 Report post Posted August 19, 2013 Hello Sir, How to show the boundary layers at serval stations for an aftbody of a ship? See the attached picture. planeCUts.bmpI found I still failed to do it although Claus has shown me how to realize it just two weeks ago :wacko: . Please tell me how to do it step by step.Thank you very much! Best wishes,Jingjing Share this post Link to post Share on other sites
Mr. Claus Abt 14 Report post Posted August 19, 2013 Hi Jingjing, You have to extract a GridPlaneCut from the combined mesh and apply a ContourPlot on the extracted data. In the ContourPlot you have to chose the mapped Data, e.g. velocity.Hope that already helps. Best regardsClaus Share this post Link to post Share on other sites
Mr. Li Tongyu 0 Report post Posted August 20, 2013 Hi Claus, A problem I met is that I found there was no choice for the mapped data at all in the ContourPlot. Probably, did I miss some very detailed things? Jingjing Share this post Link to post Share on other sites
Mr. Claus Abt 14 Report post Posted August 20, 2013 Hi Jingjing, No, you have not missed anything! Seems like you ran into a bug. When I showed it to you on your computer it might have been the previous release, right? We'll come back to you asap. CheersClaus Share this post Link to post Share on other sites
Stefan Wunderlich 6 Report post Posted August 20, 2013 Hi Jingjing, Indeed, there is a bug with the connection of the plane cut.Fortunately, we are just about to finish a maintainance release (3.0.10), so this bug will be fixed then.The release will be available probably today or tomorrow. Thanks for your observation! Best regards,Stefan Share this post Link to post Share on other sites