Ms. Filipa Sanches 0 Report post Posted March 1, 2016 Hi, I'm trying to use the Lackenby transformation but I'm having some problems. I keep getting an error "failure in delta curve generation" and do not understand why. There is a range of Cp delta and delta XCB for the transformation work? Aconcelham that values enter the xBegin xend and the Aft-bofy and Fore-body? Thank you very much for your attention Best Regards Filipa Sanches Share this post Link to post Share on other sites
Jörg 29 Report post Posted March 1, 2016 Hi Filipa, Difficult to tell what's wrong in your situation without seeing the example. Some of your input values seem to make problems, maybe they are too large etc? There is no explicit range or limitation. Aftbody xbegin and Forebody xend are required input as far as I remember. Maybe you can post a simplified example which does not work to discuss things? CheersJörg Share this post Link to post Share on other sites
