Dear all,
I'm having some issues trimming the Brep or Surface either with curves, surfaces or Breps. My intention is to parametrize the end of the Brep or Surface in order to end at the transom (x=0) of the hull, while at the same it follows the step.
I manage only to trim the surface (04_UpperSectionSurface) first on the principal plane (X=0) first and then trim the Brep (06_Step|Upper_Section_Brep) on the step geometry, however this ends with some discrepancies on the final Brep, due to the initial trimming of the 04_UpperSectionSurface.
I'm attaching a few screenshots of the area, while also the model. Could you please advise upon the matter?
Thanks a lot.
Best regards,
George
TestSWAN_v2.cdbc