Export wavecut data points from shipflow

[Mr. George Kavvas 0]

Hello everyone,

 

I am currently working on my thesis <Optimazation of a sailing catamaran> and I am using

CAESES for the parametric model and SHIPFLOW for the potential solver. 

So far so good I managed to run shipflow without any errors. Now I would like to present

my results of the wave pattern and more specifically I want to export the data points of 

a wave-cut curve.

 

Concerning the shipflow manual there is a build-in configuration for wavecuts under XPAN commands.

At first I tried to follow the shipflow manual ( with lwavec= [0.5] and dxwave= [0.01] )

but the result output file LWAVECUT was empty.

 

I have produced the wave-cut curve at y/L=0.5 by using a PlaneCut in the free surface object.

 

But I would like to have the data points of that 2d curve in order to compare it with that of the

initial design and i can't really figure out how to.

 

Could you please advice on how to proceed.

 

Thank you in advance

George Kavas

National Technical University of Athens