Mr. Carlo Pasquinucci 1 Report post Posted November 1, 2016 Hey Guys, I prepared a simple example of a Bulb Deformation using Delta Shift and Surface Delta Shift starting on an original STL file. Two easy tricks: _ The creation of sections in Y-Direction on the surface for the Surface Delta Shift, that can help you to understand the deformation amount. _ The split in two different ImageTrimesh, in oder to apply the Delta Shift only on the lower Trimesh.It is not the most robust way, but it is the faster and very easy to understand. I hope that this example can help you! Cheers, Carlo ExampleForForum.fdbc Share this post Link to post Share on other sites