Ms. Nabila Naz 0 Report post Posted May 9, 2016 Hello, I am trying to perform Lackenby shift for KCS hull. But after computing hydrostatic calculation, the initial sectional area curve does not maintain uniformity at bow of ship (screen-shot attached) Would you please tell me how to make it uniform i.e., make the curve smooth without any break at forepart ? Regards,Nabila Share this post Link to post Share on other sites
Matthias Maasch 21 Report post Posted May 9, 2016 Dear Nabila, could you please share your Lackenby settings or your CAESES project. If you don't want to share it here in the Forum you could send it via email. Best Regards Matthias 1 Share this post Link to post Share on other sites
Ms. Nabila Naz 0 Report post Posted May 10, 2016 Dear Matthias,Email has been sent. Thanks Share this post Link to post Share on other sites
Matthias Maasch 21 Report post Posted May 12, 2016 Hi Nabila, the file you send doesn't contain a Lackenby Shift. Could you please check and send the correct file. Thank you Best Regards Matthias Share this post Link to post Share on other sites