Mr. Victor Bolbot 1 Report post Posted December 7, 2015 Hi, When I wanted to present results of an optimization process, it was necessary to adjust axis discretization. For instance, the discretization in x-axis was 0.0714, 0.243, while I wanted 0.1, 0.2, etc as can be seen in attached picture. The same happened with y-axis. As I understood, that is not possible in CAESES, so I had to use other utility. This is a change I would really like to see in CAESES. Regards, Victor Bolbot Share this post Link to post Share on other sites
Mr. Claus Abt 14 Report post Posted December 7, 2015 Hi Victor,You can set the bounds of the variables in the dialog. Modify them such that the range is divisible by 7, then you get nice numbers.CheersClaus Share this post Link to post Share on other sites