Jörg 29 Report post Posted September 3, 2014 Hi,We have observed that users sometimes get confused by the mirror functionality which doubles the geometry by scaling the y-coordinate with a factor of -1. This is just for visualization! In most situations, this is not required by non-maritime users. However, for ship hull designers, a symmetric ship hull can be quickly mirrored with this button, just to have a look at the entire ship hull (while modeling only one half of it). I hope this helps,Joerg 1 Share this post Link to post Share on other sites
Mr. Claus Abt 14 Report post Posted September 3, 2014 The same applies for the section view or no-section view. We might think of predefined industry specific setups for the GUI. That also applies for the selection off features. Let us collect some ideas.CheersClaus Share this post Link to post Share on other sites
Karsten Wenzke 12 Report post Posted September 3, 2014 Hey, you can also use the shortcut 'F5' to turn the mirroring on and off. Cheers, Karsten Share this post Link to post Share on other sites