Jump to content

Search the Community

Showing results for tags 'STARCCM+'.

The search index is currently processing. Current results may not be complete.


More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • CAESESĀ®
    • General Modeling
    • Software Connections
    • Variation & Optimization
    • Post-Processing
    • Feature Programming
    • Installation
    • Miscellaneous
    • Ideas and Suggestions
    • FAQ

Categories

  • Articles
    • Forum Integration
    • Frontpage
  • Pages
  • Miscellaneous
    • Databases
    • Templates
    • Media

Categories

  • New Features
  • Other

Blogs

  • Mr. Arne Bergmann's Blog
  • FSYS DAEHWAN PARK
  • Mr. Arne Bergmann's Blog
  • Rel 3.1
  • Joerg Palluch's Blog

Calendars

  • Community Calendar

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 3 results

  1. Dear all, I've created a trimesh (FTrimesh) from a BRep hull geometry, which I'd like to export in an form in order to import it into STAR-CMM+, while also later I'd like to run an hull optimization run. The first issue is that while the Open Edges option is active, in the 3DView it shows none open edges, while simultaneously it shows that there is 1 Open Edges at the Info panel. This leads to an number of issues while trying setting up the STAR-CMM+ simulation, since it cannot create volume meshes. The next question is how can I increase the density of the tessellated geometry, in particular the number of triangles on the created mesh? Is there a way to modify the triangles in other ways, such as isoscales triangles, or similar options? Thank you very much for your time and consideration. George. Tecopt_v1.cdbc
  2. Hi everyone, I coupled CAESES and Starccm+. I'm trying a cycle out. As you can see on screenshot, it says n/a for "eval_coeff"; but when i click on created design, i can see the value on the left side. It does not count in the "eval_coeff" value when making evaluation. How can I overcome this problem? Any idea?
  3. Ladies and Gentlemen I have a short introduction about the evaluation project of propeller open water test using CAESES + STARCCM+. You can find the whole contents at the link below. GO :D
×
×
  • Create New...